Homa Installing 8 Inch and Larger Profile Seals Manuel d'utilisateur télécharger pdf

Publication

88LM2036

Please Contact

Technical Support At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 1

Installing 8” and Larger Profile Seals

When installing a profile seal, one side of the seal is wider than the other. This WIDER SIDE goes

in FIRST. Measure both sides first to be certain which is larger.

Apply a thin coat of dishwashing detergent to the back (the side touching the claw) and sides

of the profile seal if desired and gently tap the seal into place using a SOFT FACED hammer.

If the seal goes in easily, it is most likely backwards.

When installed properly, the seal forms a “dovetail” with the claw.

REMEMBER: the larger diameter always goes to the inside.

Page 1

Publication 88LM2036 Please Contact Technical Support At 203-736-8890 With Any Additional Questions Please Be Prepared To Provide Pump Serial Number

Pas de commentaire

Homa Installing 8 Inch and Larger Profile Seals Manuel d'utilisateur