Homa H Series Manuel d'utilisateur télécharger pdf (Page 2)

H Series

PUMP

Installation, Operation, and Maintenance Manual

GENERAL INSTRUCTIONS:

This manual is intended to provide basic

installation and start-up guidance. It is to be read

and thoroughly studied prior to attempting to

install or operate any of the equipment supplied.

Equipment damage, which occurs by not

following these instructions, will void the

warranty.

SAFETY PRECAUTIONS:

Only trained qualified personnel shall be utilized

for installation and start-up.

The following is a general list of safety

precautions that should be followed when

installation starting-up or servicing the pump.

The pump station owner or operator is

ultimately responsible for ensuring that all

equipment is installed, started up and

operated in a safe manner.

1. Do not work alone.

2. Double check to make sure that all lifting

equipment is in good working order and that it

has adequate lifting capacity for the weight that it

will handle.

3. Wear safety helmet, goggles and protective

shoes, or appropriate safety materials required.

4. Before working on the pump make sure that

the power is disconnected and cannot be

energized by others. Lockout and tag the control

panel circuit breaker.

5. Do not stand under suspended loads!

6. Never enter or work within a wet well without

first checking to make sure sufficient oxygen is

present and that there are no explosive or

poisonous gases present.

7. All personnel, who work with sewage pumping

equipment and systems shall be vaccinated

against diseases that can occur, If there are any

questions or doubts in this area it is strongly

suggested that the local health agency be

contacted.

EQUIPMENT INVENTORY AND

INSPECTION:

Upon arrival of pump shipment carefully unpack

all components and compare with shipping and

purchase order documents to ensure that the

order is complete. Also inspect equipment for

any damage that might have occurred in

shipment. If any problems are detected contact

an authorized Homa Pump Technology

Representative immediately.

TRANSPORTATION AND STORAGE

PROCEDURE:

Always lift the pump by its lifting bail or eye.

Never lift the pump by its power cable!

The power cable ends must be protected from

immersion in water as well as moisture intrusion.

The cable will wick if it is not protected properly.

Power cable leads shall be covered with shrink

tubing.

Short-term storage is defined as any time less

than six months. We recommend for this time

intended to store the pump in its original

shipping container in a dry, temperature

controlled area. If climate controlled storage is

not possible, all exposed parts should be

inspected before storage and all surfaces that

have the paint scratched, damaged or worn

should be re-coated with air dry enamel paint.

Any storage time exceeding six months is

considered long term. In addition to the

safeguards specified above, the impeller should

be rotated once a month to prevent the

mechanical seals from being damaged, and the

pump should be inspected. The oil in the

mechanical seal chamber should be drained and

replaced.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire