Homa T-motor voltage change Manuel d'utilisateur télécharger pdf (Page 2)

7. Re-connect the wires as seen in

(Fig. 4).

8. Separate the wire bundle with wire

number 2 and re-connect as seen in

(Fig 4).

9. Separate the wire bundle with wire

number 3 and re-connect as seen in

(Fig 4).

Fig. 4

10. Double-check all wires have been

connected correctly.

11. Gently tuck wire bundles behind stator

windings, being certain nothing

extends below the motor housing.

(Fig. 5)

12. Place wavy washer back on top of

upper bearing and verify large motor

housing o-ring is positioned in its

groove.

13. Slowly and carefully lower motor

housing onto pump (DO NOT ALLOW

ROTOR TO SCRUB AGAINST

STATOR.) For T-motors, re-connect

seal probe.

Fig. 5

14. Re-attach motor housing to volute with

cap screws.

15. Record voltage change in pump

service manual.

16. Pump is now ready to operate.

Publication

88FN2046A

Please Contact Technical Support At 203-736-8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

2 of 2

1 2

Pas de commentaire

Homa T-motor voltage change Manuel d'utilisateur Page 2